>You are here: Home > Case Studies
Shanghai Wanggang substation is a 220kV substation located at Pudong district, Shanghai. The substation is managed by Zhangqiao dispatching center. The substation has two (2) 180,000 kVA transformers, four (4) incoming supply lines of 220kV and nineteen (19) outgoing feeders of 35 kV.

Challenges

The existing interlocking system deployed in the Shanghai Wanggang substation is an offline system, the Smart Key is unaware of the primary equipment status changes during the operation. Without real-time communication between Smart Key and Smart Interlock System host, the interlocking system can only enforce a series of predefined orders without validating each step. Meanwhile a single operation can only be stored in a single Smart Key. Operators are required to travel back and forth between control room and the field frequently for a complicated switching task. All these shortcomings greatly constrained switching operation efficiency.

Benefits

Unitech JOYO series Smart Interlock System achieves the following benefits:

■ Real-time status update on Smart Interlock System Host
■ Real-time validation and authorization before each switching steps
■ Unique operation privilege enforcement
■ Video monitoring of primary equipment during operation
■ Reduced operation workload and training cost

Solution

JOYO-B43 Smart Interlock System was the answer to above challenges. JOYO series smart interlock system features a five step process that incorporate simulation before switching and step by step validation.

Step 1: Simulation

Operation orders are simulated on SIS Host to verify its correctness. SIS host consists of a rule database and one line diagram of primary equipment that will facilitate the simulation, thus prohibits any faulty switching operation.

Step 2: Transmission

Once the operation procedure is validated on SIS host, the electronic switching order will be generated and transmitted to the Smart Key. There are two types of communication methods supported between Smart Key and SIS host, wired bus connection and low power consumption wireless communication. The operator is ready for field work once the transmission is finished.

Step 3: Device Verification

By following the instruction showed on Smart Key, the field operator can easily locate designated devices. Before any actual operation, the device must be identified by the Smart Key. In order to achieve universal identification, RFID is embedded in locking mechanism of each device.

Step 4: Operation Validation

Instead of following a predefined procedure, once the device is verified, the Smart Key will send a request to SIS host to validate the operation. SIS host will make the decision based on real-time equipment status, which is much safer than assuming the system will preserve previous status. Also, the SIS host will ensure only one operator can request operation on a particular equipment at any given time.

Step 5: Switching

Once the switching operation takes place, SIS host will be aware of any primary equipment status change directly through acknowledgement from Smart Key or indirectly from SCADA/EMS system.




Contact Us
For international sales contact:
[email protected]
1-916-293-3283
六合彩96期特码资料 福利彩票3d预测方法 乐天盈股票配资平台 河北11选5开奖结果走势图爱彩乐 九娱乐平台下载app 黑龙江省福彩22选5综合 024体彩排列3藏机图 吉林11选5走势 湖南福彩动物快乐十分计划 智操盘 北京11选五专家预测